P 2.5

* Input voltage DC 3.3 V–5.0 V
* Rated current 0.5 A
* Rated power
* consumption 2.5 W
* Operating
* Environment
* Temperature –20°C to +70°C
* Humidity 10% RH to 90% RH, non-condensing
* Storage
* Environment
* Temperature –25°C to +125°C
* Humidity 0% RH to 95% RH, non-condensing

* Color Management
* 18Bit+
* Point-by-point brightness and chromaticity correction
* Quick bright and dark line adjustment
* 3D function
* RGB independent Gamma adjustment
* The screen rotates in multiples of 90°
* Mapping function
* pre-stored screen settings
* Temperature and voltage monitoring
* Cabinet LCD display
* Error detection
* Firmware program readback
* Configuration parameter readback
* Loop backup
* Dual backup of configuration parameters
* Dual program backup

* Brightness Calibration Working with NovaLCT and calibration platform,the receiving card supports brightness calibration on each LED, which can effectively remove brightness difference and greatly improve display brightness consistency, allowing for better image quality. It is recommended that CalCube MiniLED V1.1.0 or later be used as the calibration platform.
* Quick adjustment of dark or bright lines The dark or bright lines caused by splicing of modules or cabinets can be adjusted to improve the visual experience. The adjustment can be easily made and takes effect immediately.
* 3D function Working with the sending card that supports 3D function, the receiving card supports 3D output.
* Individual Gamma adjustment for RGB Working with NovaLCT (V5.2.0 or later) and the sending card that supports this function, the receiving card supports individual adjustment of red Gamma, green Gamma and blue Gamma, which can effectively control image nonuniformity under low grayscale and white balance offset, allowing for a more realistic image.
* Quick uploading of calibration coefficients Upload the calibration coefficients quickly to the receiving cards to improve efficiency.
* Mapping function The cabinets can display the receiving card number and Ethernet port information, allowing users to easily obtain the locations and connection topology of receiving cards.
* Setting of a pre-stored image in receiving card The image displayed on the screen during startup, or displayed when the Ethernet cable is disconnected or there is no video signal can be customized.
* Temperature and voltage monitoring The receiving card temperature and voltage can be monitored without using peripherals.
* Cabinet LCD The LCD module of the cabinet can display the temperature, voltage, single run time and total run time of the receiving card.
* Bite error detection The Ethernet port communication quality of the receiving card can be monitored and the number of erroneous packets can be recorded to help troubleshoot network communication problems. NovaLCT V5.2.0 or later is required.
* Firmware program readback The receiving card firmware program can be read back and saved to the local computer. NovaLCT V5.2.0 or later is required.
* Configuration parameter readback The receiving card configuration parameters can be read back and saved to the local computer.